KX Riders

Maintenance & Technical => KX500 Original => Topic started by: Gund3rs on September 21, 2018, 09:30:00 PM

Title: Kx500 1987 clutch cover ??
Post by: Gund3rs on September 21, 2018, 09:30:00 PM

Hi i am fixing my 500 little bit, pictures comes 😎 i need a new clutch cover tho...  then the enigne is almost finnish, with new sylinder and a inside makeover Etc 👍so my question is IT anyone om this forum who have a clutch cover to 1987 engine for sale  ? Grettings from norway 😎😎

Title: Re: Kx500 1987 clutch cover ??
Post by: Gund3rs on September 29, 2018, 07:08:00 PM

.. any one have a another one in better condition? :)

Title: Re: Kx500 1987 clutch cover ??
Post by: sandblaster on September 30, 2018, 02:19:31 AM

Ouch...

Title: Re: Kx500 1987 clutch cover ??
Post by: KXDINO on September 30, 2018, 09:06:52 AM

good chance the gear lever shaft done that damage , be carefull when the engine on that side were the gear lever bolts on without the lever bolted on , it can get pushed through the cover.

Title: Re: Kx500 1987 clutch cover ??
Post by: Gund3rs on December 04, 2018, 04:12:48 AM

Kxdino : yes it sounded like a sensible explanation of the injury :) There was a lot of packing silicone over so did not see the damage until now when I started full bike restoration after many years in the garage. hope someone has a good tips for respirator or have one for sale for not having gold to diamonds for that then hehe. With kind regards, Jørgen Sg 8-)

Title: Re: Kx500 1987 clutch cover ??
Post by: jeffro351 on December 04, 2018, 07:29:54 AM

I just purchased one of of ebay for a extra, and also some some new ones on there.