KX Riders

Maintenance & Technical => KX500 Original => Topic started by: mikesmith on April 04, 2003, 07:37:03 PM

Title: foot peg mounts
Post by: mikesmith on April 04, 2003, 07:37:03 PM

Any one use Terry Cable or Pro Circuit foot peg mounts.If so are they a lot stronger than stock.I noticed my peg was getting sloppy,had about 1/4" play were the mounts bracket had spread.

Title: foot peg mounts
Post by: KX142 on April 05, 2003, 12:30:29 PM

I bent the mount on mine and got the tery cable mount to replace it. it looks a lot stronger, but the pin isn't long enough for the cotter pin to go in so I had to drill a new hole in it. Haven't bent this one yet!

Title: Pegs
Post by: Greenrider on April 07, 2003, 02:14:31 PM

Terry Cable has two different fixes for this problem. First is a kit with oversized pins and a drill bit. You drill out the stock peg mounts and install the oversized pins to tighten things up. Second is a bullet proof left side peg mound that is much stronger than stock, both are excellant products!