KX Riders

Maintenance & Technical => KX250 / KX125 => Topic started by: tommytwo on April 05, 2012, 01:04:24 PM

Title: linkage and swingarm bearing installation
Post by: tommytwo on April 05, 2012, 01:04:24 PM

Hi KX'ers. Was wondering if anyone had a diy layout on how to install linkage and swingarm bearings on 2003 KX 125.

Cheers!

Title: Re: linkage and swingarm bearing installation
Post by: royceymon@hotmail.co.uk on April 09, 2012, 07:12:25 AM

diy : sockets and studding with nuts and washers i have used when i hadnt the tools with me this was an emergency job though! otherwise solid bar on the lathe ,press out, worst case drill lathed up parts and use studding ,two spanners etc!