Maintenance & Technical > KX500 Original

Clutch cover material

<< < (3/3)

kwakman:
I know, it was me that had seen it at barbon, a good way back.do you know if it has bigger main bearings than stock, and are your other casings mag too, or just clutch? im in Notts.K.

bike_boy_england:
i havent had the crank cases apart on this engine, but comparing flywheel sides to a 92 engine i have they look the same. the flywheel cover is made of ali. if all goes to plan it will be getting some other mods over winter which require cases to be split!! I cant wait to be honest! alex

littlewing78:
Here is a picture of the crack from the inside of the case.  The outside is currently covered in JB Weld.  Which by the way, got me through a 70 mile desert race.

Navigation

[0] Message Index

[*] Previous page