Maintenance & Technical > KX500 Original
Check these fiber clutch plates out
sniper1:
Now this is what the fiber plates should look like :) they came in 3 days from order and were in stock at motosport $96 delivered to my door I like that.
1989kawasaki:
sweet :-D
sniper1:
Thanks now I can install the clutch parts :)
Polar-Bus:
--- Quote from: sniper1 on June 29, 2011, 02:31:49 PM ---Thanks now I can install the clutch parts :)
--- End quote ---
Be very carefull tightening the pressure plate spring bolts. They are designed to "bottom out" . So make sure you make them just tight enough, those 6mm bolts are easily snapped from people cranking down too tight on them...
1989kawasaki:
--- Quote from: Polar-Bus on June 30, 2011, 12:13:15 AM ---
--- Quote from: sniper1 on June 29, 2011, 02:31:49 PM ---Thanks now I can install the clutch parts :)
--- End quote ---
Be very carefull tightening the pressure plate spring bolts. They are designed to "bottom out" . So make sure you make them just tight enough, those 6mm bolts are easily snapped from people cranking down too tight on them...
--- End quote ---
i learned that the hard way on my rm250
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version