Maintenance & Technical > KX500 Original

Project "I was only gonna clean the air filter!"

<< < (58/74) > >>

USMC 500:
Today is a good day.......To start off mr. mailman dropped off a package that contained a set of these.....



Then a mysterious present that is shaped like a set of tires appeared under the tree......



Soooooooo.....there was only one thing left to do, PREPARE..... :-D





Out with the "stock" and "old"........



And in with the "cool" and "new"......



Unfortunatly I have to wait till Midnight to open the "mystery" present so I can mount my new Dunlop MX71 90/100-21 & Maxxis Desert IT 120/100-21....at least I think thats what santa brought me :-D

I did however find a problem with the bike........A MISSING CDI!!!



Then I realized that I have one of these.......



Gotta love that MZB ignition!!!!  I'll post up the finished product once that family lets me open my presents :cry:

Foxx4Beaver:
What are you gonna do if Santa decided a set of rock hard Cheng Shins that have been laying around a warehouse the last 6 years is what you're gettin stuck with? :?

Motorrad:
any guess how much the links raised the bike?

USMC 500:

--- Quote from: Motorrad on December 24, 2012, 12:34:55 PM ---any guess how much the links raised the bike?

--- End quote ---

I'll measure it and give you a value.

With the bike on the stand and the rear end unloaded I measured on the left side of the bike using the 8mm seat bolt to the center of the rear axle as reference.  I end up with an additional 10mm of height on the back end using those reference points with the EMIG Racing Dog Bones.  FYI, I am on the toilet as I type this...... :-D

Motorrad:

--- Quote from: USMC 500 on December 25, 2012, 06:01:25 AM ---
--- Quote from: Motorrad on December 24, 2012, 12:34:55 PM ---any guess how much the links raised the bike?

--- End quote ---

I'll measure it and give you a value.

With the bike on the stand and the rear end unloaded I measured on the left side of the bike using the 8mm seat bolt to the center of the rear axle as reference.  I end up with an additional 10mm of height on the back end using those reference points with the EMIG Racing Dog Bones.  FYI, I am on the toilet as I type this...... :-D

--- End quote ---

Appropriate since I'm reading it on the toilet

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version