Maintenance & Technical > KX500 Original

86 kx5 swingarm

(1/2) > >>

zskunk:
does anyone know what the measurement should be at on the bearings? my clymer book doesn't tell me and i don't think there right. someone had a bunch of washers in place where the dust seals should be ..

sandblaster:
For the wheel, from the outside to the outside of the bearings is approximately 144.5MM.
If you have the correct wheel it should be stamped R-1158 on the hub.

zskunk:
so is this where the swingarm bearings should be set at with the dust seals in ? outside to outside?

sandblaster:
Oh, sorry, that is where the rear wheel bolts on.
Turns out I have a swing arm for a 86.
I'll try to get you some dimensions on Monday or Tuesday.

zskunk:
thanks sandblaster!!

Navigation

[0] Message Index

[#] Next page