Maintenance & Technical > KX500 Original

some bottom end questions

<< < (4/14) > >>

jonny500:
the sellector forks need to be measured to see if they are within spec. the gear should be replaced, also check the drive dogs on the side of the gears for rounding. the crank is not usable, the journal is down on size. 29.95 will spin in the bearing. you need to buy a new crank half or find someone that can repair it. i would do all the bearings inside the casings to be sure

tschisi:
Do you know the values for mearuring the shift forks?
Can i find them in the clymer manual here in the forum?

Can anytone tell me the size of the 5 inner ball bearings?
I want to check prices of standard bearings, and don?t know if it?s good to measure the size of my used bearings...

jonny500:
yes all specs are in the clymer. is it a kx 500?.

tschisi:
Yes, a 1990.

Friar-Tuck:


look around here for some more info: http://s69.photobucket.com/home/Friar-Tuck/index


and click forward from here: http://www.kxriders.com/coppermine/displayimage.php?album=lastup&cat=1&pos=12
 8-)

Navigation

[0] Message Index

[#] Next page

[*] Previous page