Maintenance & Technical > KX500 Original

pipe brackets

(1/2) > >>

bp:
I have 02 kx 500 w/ zipty tank and pipe,and i keep breaking the
pipe brackets(rubber). is there stonger aftermarket ones or a
trick to keep them from breaking.

mikesmith:
Ill tell you one thing,dont weld by them,when they get real hot they seperate.I made my own out of aluminum stock,some heater hose with fuel line inside of it and a bolt through the hole thing.Ive only had one break after all these years of doing it and it was the aluminum stock that broke after a few hard impacts!

teamgreen500:
This "Breakage" is usually a sign of a pipe that doesn't fit correctly OR over-tightening that causes the mount tp spin.

Manny

SLEEZ:
Mike,

Do you have a pic of your bracket?

DanH1:
When I mounted my  Flow/ZipTy pipe I did have to bend the mounting tabs on the pipe just a little and elongate one of the holes very slightly to get the mounts to line up. They should bolt up without any tension on the rubber, otherwise they will break. Make sure you don't put a twist in the rubber when tightening, this will break them also.     Dan

Navigation

[0] Message Index

[#] Next page