Maintenance & Technical > KX500 Original
Site window Piston
kaw rider:
yes i can machine your head. Depends on what you use the motor for. My heads are machined different then the ones on here. I would play with the timong to see what you like.
mwalker04:
Well, she was running rough at first. I found that the clip for the carb needle in the slide was bent to hell. The needle was sitting way lower than It should have been. A new clicp from ace hardware fixed that and shes running prime!
mwalker04:
Here she is
martinfan30:
--- Quote from: mwalker04 on October 18, 2010, 02:40:58 AM ---Here she is
--- End quote ---
Nice ride!! :-D
mwalker04:
And another.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version