Maintenance & Technical > KX500 Original
look what i made at work
seff23:
--- Quote from: Charlie500 on September 15, 2010, 04:33:24 PM ---Bet you could sell em. Make a half dozen and post on the for sale section.... stock one cost over a hundred bucks I think
--- End quote ---
yeah their pretty close, the last one i had to buy was $90 i only got $8 and about 30 minutes in this one...lol but when i do my permanent one i'm going to take my time and make it out of stainless so it looks nice and hopefully last forever..lol
Charlie500:
Sounds cool man. Take a pic for us to see :roll:
bempa:
I hope it works ok. My experience is that any attempt using non cast fabrication for the kick it will twist slowly over time.
Polar-Bus:
Great thinking, but pray to god the weld at the base of the lever does not fail while kicking..... OUCH ! :-o
bigbellybob:
--- Quote from: Polar-Bus on September 17, 2010, 08:49:57 AM ---Great thinking, but pray to god the weld at the base of the lever does not fail while kicking..... OUCH ! :-o
--- End quote ---
i think it would bent before the weld would brake.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version