Maintenance & Technical > KX500 Original

How to get this bearing out

<< < (4/4)

BDI:
my dad told me that one but he said to use a wooden dowle so not to damage anything. He says it works and if pops says it works :wink: it does. I have never found myself in a situation that I thought it would work, not to mention my ocd side has a fear of cleaning grease off the ceiling. You know for a long time I wouldn't eat ribs because of the barbeque sauce. Anyway That is an awsome trick I never thought of mentioning because I didn't think it would work in this case but some day some where some one will get to use it. Good call for sure  :|

 P.S. maddog and I post are posts at the exact same time. I just thought that was way cool.

maddoggy:
bdi, you need to come up to my place and we'll have some beer and eat smoked ribs. no bbq sauce to be afraid of.

BDI:
I would love to  :-) man I could use a vacation. By the way My wife laughed at me enough I got over the sauce but I will have a stack of towles when I'm done. I love me some ribs, sweet baby rays MMMMMM

Polar-Bus:

--- Quote from: BDI on June 07, 2010, 04:43:50 PM ---my dad told me that one but he said to use a wooden dowle so not to damage anything. He says it works and if pops says it works :wink: it does. I have never found myself in a situation that I thought it would work, not to mention my ocd side has a fear of cleaning grease off the ceiling. You know for a long time I wouldn't eat ribs because of the barbeque sauce. Anyway That is an awsome trick I never thought of mentioning because I didn't think it would work in this case but some day some where some one will get to use it. Good call for sure  :|

 P.S. maddog and I post are posts at the exact same time. I just thought that was way cool.

--- End quote ---

It's funny you mention "wooden dowel" I remember back in trade school, learning to extract clutch pilot bushings on cars and trucks, by packing grease in the bushing, then finding a snug fitting dowel, then smacking the dowel wirth a hammer. The dowel forces extreme hydraulic pressure on the backside of the bushing forcing the bushing outwards. I't worked too.

Navigation

[0] Message Index

[*] Previous page