Maintenance & Technical > KX500 Original

V-ForceD2 Set up Tips?

<< < (3/3)

Folke:

--- Quote from: KXcam22 ---Not quite sure what part you're cutting, but for cutting rubber if you grind the sides off a new hacksaw blade (the parts of the teeth that stick out a bit on each side and gives the width of the saw cut) it cuts rubber very nicely. Hope it helps. Cam.
--- End quote ---
Has anyone tested V-Force 3 on KX 500 and whats the different from VF2 ???

barryadam:
Is there a top or bottom to the V-Force 2?  I see the logo on a tab, but it looks like it might just hit the cylinder casting line at the top of the mounting flange when torqued down.  I think I'll try it at the bottom.  The instructions don't say there's a top or bottom, and it's too late to call tech support.

B

Timbowe:
Just file it off. Its no biggie.

barryadam:
Thanks Timbowe.

Put it on logo facing downward anyways (downunder?).

Hopefully, it's all good tomorrow.

B

doordie:
Folke,
you tried that on your mean green,don?t you remember :?
I think it?s no different in power between vf2 and vf3, but you can change reeds without any tools on vf3. :wink:  

//doordie

Navigation

[0] Message Index

[*] Previous page