Maintenance & Technical > KX500 Original

Sealing my transmission output

<< < (2/2)

tschisi:
I now replaced the seal, the o-ring and the coller.
I pushed the seal that far into the case that it alignes with it.
Guess that?s right?!

Friar-Tuck:
 Yes that's correct.
The oil seal seats flush with the case.     (Clymer M447-2 pg.181)

  O-ring goes on the output shaft 1st then the sleeve/spacer  then sprocket & Clip  (Service Manual 9-2 Final Drive) 
  Tuck\0/

Navigation

[0] Message Index

[*] Previous page