Maintenance & Technical > KX500 Original

Cylinder torque

<< < (2/3) > >>

Bigtim:
I like the motion pro tool best bc of the closed end, I've never seen a " closed end" crowsfoot ever. But I just had my elbow calibrated to +/- 2lbs. :-D

junk man:
so dose anyone know the values if your offset is three inch. i know there's a chart but i don' have one

Friar-Tuck:
You do now  :-D
http://www.motionpro.com/documents/pdf/08-0134.pdf
  \o/

kwakman:
all my tool box needs now is a collapsible, oil proof tuck-o...... :-D

junk man:
thanks tuck it will in my manual when i get my printer hooked up

Navigation

[0] Message Index

[#] Next page

[*] Previous page