Maintenance & Technical > KX500 Original

Rebound Spacer???

<< < (3/5) > >>

kawdude:
I found the attached sizing charts and will use according.  I'm putting this info out for future reference and also suggest it's placed in the FAQ's.  :idea:



--- Quote from: Paul ---Look for a 15MM drill bit, MAY be able to find it at Sears or a Harbor Frieght
--- End quote ---

kawdude:
Another attachment listing bolt, tap, and hole tolerances.

Paul:
I'll add it to the computer toys ;)

kawdude:
Cool.  Sears and Harbor Freight do not have the right size bit.  I'll keep looking.

kawdude:
Well guys the bit size that is needed is a 15mm or 19/32" and finding one has been impossible.  The good news is I found one in a coffee can buried in the local scrap yard.  It a rusty piece of crap but at least the right size.  Drilled the holes adding 5/8" to the length.  WAY TOO much but a good test.  I would say that increase in the dog bones lowered the seat by 4+ inches.  I will make another set and add 3/8" of an inch to see what that does.

Navigation

[0] Message Index

[#] Next page

[*] Previous page