Maintenance & Technical > KX500 Original

tight clutch

<< < (2/2)

hughes:
What about the clutch arm bearings?

cbxracer30:
try a MSR Raptor clutch lever system 300 percent easier pull on the clutch lever, I've been running them for years.CBX

bob larry:

--- Quote from: cbxracer30 on January 11, 2010, 12:12:40 PM ---try a MSR Raptor clutch lever system 300 percent easier pull on the clutch lever, I've been running them for years.CBX

--- End quote ---

Any pics of this installed?  I have been looking at the hydro clutch system for $259 but seems like too many parts for me, more things to break.
I tried a KTM with a hydro clutch and it was so sweet but no sure about the after market stuff.

hughes:
http://www.powersports.magura.com/en/home.html

I think this is the one KTM uses and the most used for aftermarket guy's.

kwakman:
use a crf lever, teflon cable (well lubed), extend actuator arm by 7.5mm, polish actuator arm face,check arm bearings and seal to keep dirt out, and check your clutch basket fingers for grooving. if it aint easy after this, you need more spinach in your diet. agg agg agg agg ag........

Navigation

[0] Message Index

[*] Previous page