Maintenance & Technical > KX500 Original

Silencer Repacking

(1/3) > >>

blueoval:
How in the heck do I get this apart?  Any suggestions would be welcomed.  thx   

RM_Rider14:
PB Blaster etc. around the ends.  Grab (with pliers wrapped in a cloth) the tip and pull while holding the rest of the housing.  You'll have to wiggle it a bit too.  This is assuming you already removed the nuts/rivets.  Can't tell in that pic'.

Friar-Tuck:
 :-D
http://www.youtube.com/watch?v=RNxKO18I-3I&feature=PlayList&p=05D78019F3186623&playnext=1&playnext_from=PL&index=12
  This is a  lot faster than I could type!
  Not exactly the same, but you'll get the Idea.   
    Tuck\o/

JustinSB:
Remove the bolts at the "entrance" end. Then place that end in a vice and pound the s**t out of the silencer body with a mallet.

hughes:
This may help you click the link. http://www.fmfracing.com/TechSupport/Repacking

Takes a minute or so for the video to load but worth the wait.

Navigation

[0] Message Index

[#] Next page