Maintenance & Technical > KX500 Original

Cables?

(1/2) > >>

kawdude:
All, I'm in need of new throttle cable and I'm wondering what you all recommend?  I've heard horror stories about aftermarket cables that don't fit and cause problems.  Thanks in advance!

NastyNick:
I picked up a motion pro cable for mine.  Would have worked just fine, except I also replaced my cracked throttle with a motion pro.  Guess what?  They don't fricken work together!  whoohoo!!  My dealer (since I am not good at cable fixing) cut the ends off the cable and fixed it up real good for me.

Try the motion pro.  It should work.

kawdude:
Any pre-setup need to be done to the cable?  How about tension.  Currently there's adjusters at both ends.  Is there a difference on where you adjust the slack?

Rick:
I use only stock cables.  

On the throttle, the key is to eliminate the throttle play so you are sure to take full advantage of the power at full throttle.  To adjust, losen the adjuster nut (with motor off) at the throttle housing, and gently feel the play as you turn the throttle off idle.  Adjust the cable so there is not any initial play, and then retighten the nut.  

I check throttle play before every race, but this doesn't require adjustment very often.

Rick

NastyNick:
I was always told that you should have 1/8" or so of free play in the throttle.

Navigation

[0] Message Index

[#] Next page