Maintenance & Technical > KX500 Original

i have no luck(my cluch does'nt work,part2)

<< < (2/2)

turtle22:

--- Quote from: Polar-Bus on December 08, 2009, 04:10:54 AM ---
--- Quote from: turtle22 on December 07, 2009, 12:58:39 PM ---so how tight should i tighten the bolts that hold the springs? not very should be the anwser. i broke two bolts and was barely torking them. does anyone know what yr cluch baskets will work on my 1989?

--- End quote ---

Mail me the inner hub, and I will machine out the broken bolts N/C as a member favor. What many people don't realize is those springs bolts are specifically designed to "bottom out" in the holes in the inner clutch hub. Alls you need is just to "snug" those bolts. I use a dab of blue loctite, and just snug them with a 1/4" ratchet. They are only 5mm bolts and they snap easily (I did the same thing on my WR250F as well)

--- End quote ---
do u mean that? cause i was looking on ebay and it looked like it was going to be an expensive mistake(lol) IM me ur address if u where :-D

Navigation

[0] Message Index

[*] Previous page