Maintenance & Technical > KX500 Original

small amount of oil in my coolent?

<< < (3/3)

no sub for cubes:
from what i can see from looking at one of the online diagrams id say for sure you need to remove the clutch cover to do it cos the seal pushes in from the inside up against a lip then the bearings and the gear shaft,if it was my bike thats where id start,drain the oil and water,replace the seal gives you chance to have a look at everything in the clutch side at the same time,replace the fluids and see if its cured the oil/water mixing.
its not a big job to do but for sure one of the best things you could invest in is a clymer manual good luck with the repair  :-)

medicman:
Do any of you guys know the OEM part #  for the gasket that would fix the above problem

JustinSB:
I believe it is 92049-1366, SEAL-OIL,MHSD8X18X10J-1. Go to your local shop and tell them you need a water pump seal.

You should really pick up one of these, they make working on your bike much easier. http://www.amazon.com/gp/product/0892879602/ref=pd_lpo_k2_dp_sr_1?pf_rd_p=486539851&pf_rd_s=lpo-top-stripe-1&pf_rd_t=201&pf_rd_i=B001V9BC8I&pf_rd_m=ATVPDKIKX0DER&pf_rd_r=18YZP4ZAPK2X251QVQ66

Navigation

[0] Message Index

[*] Previous page