Maintenance & Technical > KX500 Original
she wont rev out...
Grunty-Motor:
today i checked the stator coils. timing was spot on.
ohm readings were
black/white to black yellow = 1500 [spec 153-230]
white / red to black yellow = 9.8 [spec 7.9 -11.9]
so, one of the cricuits is reading way out - any thoughts????
Rhyno:
So, did you ever get it figured out?
Polar-Bus:
--- Quote from: Rhyno on March 01, 2012, 07:17:20 AM ---So, did you ever get it figured out?
--- End quote ---
Dude, this post was dated Oct of 2009, i'm sure Grunty is long gone....
Rhyno:
--- Quote from: Polar-Bus on March 01, 2012, 10:20:47 PM ---
--- Quote from: Rhyno on March 01, 2012, 07:17:20 AM ---So, did you ever get it figured out?
--- End quote ---
Dude, this post was dated Oct of 2009, i'm sure Grunty is long gone....
--- End quote ---
Thanks....Dude.
I'd still like to see/hear his, or somebody else's, answer to this problem.
awak100:
Probably float/fuel level buy a spare bottom carb plug, drill a hole in the center of it. Install a liquid nipple with o-ring on it with nut on the inside of the nut. screw the new plug in place, in the carb. now connect clear rubber hose to nipple and fill carb with gas from gas tank. run the hose up verticle and check the fuel level. its a very accurite way to check fuel level in the bowl.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version