Maintenance & Technical > KX500 Original

2 piece clutch cover...

(1/5) > >>

Charlie500:
anybody know of a place i can find one???

Motorrad:
From what I have read Destry commenting on... Kawasaki only made a few of these for select factory bikes....  He sold one bike with this cover on it, so there is atleast one floating around somewhere...  Another is on his personal #1 Kx500... others... dont know how many there actually were... Id like to get my grubby little hands on one as well...

KX500freak:
yea and there,s doordie who has (had) ? one , a very nice one too,
it can be done if you,re a aluminiumwelder and have some time to spend  8-)

Polar-Bus:

--- Quote from: KX500freak on April 08, 2009, 07:08:12 PM ---yea and there,s doordie who has (had) ? one , a very nice one too,
it can be done if you,re a aluminiumwelder and have some time to spend  8-)

--- End quote ---

If I remember the post correctly Doordie actually custom fabbed his own using a clear piece of Laxan, some drilling and tapping, and an O-ring to seal, very neat design, he did a great job.

Motorrad:

--- Quote from: Polar-Bus on April 08, 2009, 10:45:34 PM ---
--- Quote from: KX500freak on April 08, 2009, 07:08:12 PM ---yea and there,s doordie who has (had) ? one , a very nice one too,
it can be done if you,re a aluminiumwelder and have some time to spend  8-)

--- End quote ---

If I remember the post correctly Doordie actually custom fabbed his own using a clear piece of Laxan, some drilling and tapping, and an O-ring to seal, very neat design, he did a great job.

--- End quote ---

I forgot about Doordie's.... That was a Neet setup...  I have seen pictures of it in the Gallery, but not a thread on it... Ill have to go hunting now...

Navigation

[0] Message Index

[#] Next page