Maintenance & Technical > KX500 Original
86 kx500, blip throttle takes 5-10 secs to smooth out?? Help!!
sharpy:
Soooooooo my new riding style is ride it like I stole it and never use engine breaking. :-o It's a big change in my MO, I'm a firm believer in smooth is fast. 8-) A bit noisey with the little reving but I'm gone. Block pass anyone?? :evil:
KXcam22:
You might be able to get rid of a bit. What is your altitude and what pilot jet are you running. Cam.
BDI:
How did you check for air leaks :? Did you do an actual leak down test or did you look it over with the old eyeball. It could ba a bad main seal, that would not be that obviouse. :? Also like asked before what are your jet specs :?
sharpy:
I only checked for leaks around the intake area with starting fluid. Sprayed it everywhere while running, no change. Ok, tuned some of the idle issues out with air screw and fuel screw. Road it around the block a few times 5 min or so. Now just as it starts to run out good, ( Full temp) The idle jumps up and stays at what might seem as 1/8 throttle or so. Should I try and readjust the air and fuel at this point or are there some other issues I might check out.( new piston, rings, good reeds and just cleaned the carb and air filter but did not oil treat the foam yet) Any thoughts would be appreciated.
sharpy:
anyone?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version