Maintenance & Technical > KX500 Original
the best gasketts for the k5
Bigtim:
--- Quote from: martinfan30 on April 06, 2009, 11:11:52 AM ---Got a slight issue... Now I have everything back, I went to put on the base gasket, and the left rear hole dont line up!!
****! Have big ride coming up, what do I do? can I enlarge the hole to fit? or do I try to find a new gasket? Funds are tight, and now panic mode sets in! LOL!
--- End quote ---
ouch :-o that must be what s been happening to 1 in 30 of us....wheres the quality control?
martinfan30:
Well, I used a Dremel on the hole , and there are no leaks or any other issues.
I can say, with window mod piston, V Force 2 reeds, KIPS mods and jetting this thing is friggen stupid fast.. Also is a little harder to start. Compression is high, and now likes to kick back a bit. Have a nice gash on my right leg from it now...
BDI:
Don't kick start it without boots on and you will avoid the shin scars :-D
martinfan30:
--- Quote from: BDI on April 09, 2009, 03:33:10 PM ---Don't kick start it without boots on and you will avoid the shin scars :-D
--- End quote ---
This is a "MUST"!! LOL.
I cant start the bitch anymore in my flip flops without pain.. I like it!!
DoldGuy:
Here you go Pauly! It was just buried took awhile to find it.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version