Maintenance & Technical > KX500 Original
KX500 Wont Start!!!!
don46:
Depending on how bad, the reeds could be the culprit or maybe even a blown crank seal. as all have said, spark (at the right time, compression and fuel and it should start.
DoldGuy:
and Air :-D
cass:
HI GUYS CHECKED REEDS TODAY THERE OK ! REPLACED NGK CAP , CLEANED FLY WHEEL AND THE PICK UP`S ON STATOR PLATE! STILL WONT START! WOULD IT DRAW AIR FROM POWER VALVE SEAL WERE THE ROD COMES OUT OF THE SIDE OF CYLINDER AS IT WAS A BIT OILY WHEN I TOOK THE COVER OFF? GOING TO BUY MORE PLUGS MABEE I GOT TWO DUDS FROM MX SHOP! I`LL KEEP YOU POSTED CHEERS
Friar-Tuck:
Cass, this is really a buggar...
I'm tempted to send you my flywheel and pick-up to try..
If the plugs don't do it send me a P.M. and if you'll pay to ship them back to me I'll take them off and pay to ship to you.
Tuck\o/
cbxracer30:
Is there any chance you somehow got water down in the motor [preasure washed it,left it out in rain] ? I had an older rm250 one time, the powervalve breather came off and water got down in the motor. I had to pull motor, pull the top end and wash the bottomend out with fresh fuel before putting it back together and it fired first kick.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version