Maintenance & Technical > KX500 Original

kips for kx 500

<< < (2/2)

kaw rider:
Or reset your arm.

KXDINO:
how do i reset the arm???

i didn'y think you could ajust the arm , but it's good if you can

KXcam22:
Keep us posted on how you make out. Allways nice to help a bother down under.  I rotated my PV pins 90 degrees.  Make sure you measure the stock amount that the pins protrude from the PV otherwise it is hard to press them back in the correct amount.   You should be able to simulate the PV opening after measuring the amount the actuating rod comes out when you rev it.  Then you can simulate it on the bench to confirm the exact PV opening to see if you are not opening fully. Cam.

KXDINO:
hi guys

just to let you know that what you told  me to do did help

undid actuator arm nut turned shaft  down a bit, tighten nut and test ride got top end power back

I'll check the actuator arm  out more throughly when i get time to make sure it's opening the full amount .


thanks KX Brother's

Dino

P.S

I tried a kx250 06 gear shifter on the kx500 , its about 5mm longer it shift gears easier , so it staying on there permanently.

Navigation

[0] Message Index

[*] Previous page