Maintenance & Technical > KX500 Original

Crank Seals ???

(1/1)

KX Newfie:
Bearings seem good......but seal on clutch side definately gone.....should i do a complete tear down & change bearings anyway.....or just change seals.

I may change bearings as well (hard to tell if bearings are perfect when the cases aren't split.}  :|

hughes:
the cases need to be split to change those seals. Before those seals can be replaced the crank bearing will need to be pressed out of the cases, so I would replace everything while in their.

KX Newfie:
Right on....haven't been inside the K-5 before {figured i could get the seals from clutch & mag sides}
No biggy, she shall be done  :-D

Navigation

[0] Message Index