Maintenance & Technical > KX500 Original

Ceramic Bearings?

<< < (2/2)

demographic:

--- Quote from: tharden on August 01, 2008, 09:16:50 AM ---I play around with chain saws on the side and here is a link to another forum that talked about these bearings. May help.

http://www.arboristsite.com/showthread.php?t=46421&highlight=ceramic+bearings

--- End quote ---

Thanks for that, I have viewed that site a few times as I was recently given a "broken"* Stihl 038 chainsaw and was looking for details on it.

Good info on the bearings as well, Can't say I am going to start using them but its all good stuff all the same.
Thanks.









* As it turned out it wasn't broken at all, it just needed the carb cleaned out and fresh petrol putting in it :-D Chuffed to bits.

doordie:
I will test them now,my supermoto raceengine have to be rebuilt. :wink:

demographic:

--- Quote from: doordie on August 05, 2008, 02:21:49 AM ---I will test them now,my supermoto raceengine have to be rebuilt. :wink:

--- End quote ---
Cheers, I look forward to your reports on them and hope they work well for you.

Regards Scott.

KXcam22:
Doordie,
  The trouble is that you can really only tell if they DONT work.......Ha Ha. Cam.

doordie:
No exactly,but if it spinns with less friction,you should notice at better throttlerespons and less vibration. :-)

Navigation

[0] Message Index

[*] Previous page