Maintenance & Technical > KX500 Original
Clutch Change
don46:
--- Quote from: Hillclimb#42 on July 29, 2008, 01:12:53 AM ---The tool is called a "blind hole bearring puller" it is basically a rod and at the end it has a nut that you tighten which spreads the bottom, then a small version of a slide hammer on the upper half yanks it out. Locate a guy that has that tool and you find a guy that probably has every tool. Its pretty simple to get out the top bearring, but the bottom one definately needs that tool.
--- End quote ---
I have that tool, unfortunately it won't reach the bottom bearing, which is why I made the tool.
Navigation
[0] Message Index
[*] Previous page
Go to full version