Maintenance & Technical > KX500 Original
First Top End rebuild - Need advice - Pics included
joker_fly:
Im doing a topend rebuild also, but o cant figure out if i got an twisted actuator out off the kips assembly like the one in the pic. Does any one have a pic on where it belongs ?
Jeeks:
That pic was only to show how good the gasket remover works on decarbonizing. That's a 250 KIPS.
BDI:
--- Quote from: stewart on January 28, 2008, 11:21:27 AM ---i would not hone it with anything but the brush set up that wiesco sells for plated cylinders
--- End quote ---
Hey Stewart why wouldn't you use a ball hone?
stewart:
its been my opion that the size or diameter of the bore and proper piston clearance is not achived by using a ball hone and if those sizes are right bore dia . striaght ness .etc..... the cylinder that his been plated makes better power the more its been run and and deglassing it did not improve the power on a plated cylinder
Kawasakinut:
--- Quote from: joker_fly on January 28, 2008, 06:13:31 PM ---Im doing a topend rebuild also, but o cant figure out if i got an twisted actuator out off the kips assembly like the one in the pic. Does any one have a pic on where it belongs ?
--- End quote ---
i've got the same question about the twisted piece? w.t.h.d.t.c.f "where the heck did that come from"? i could of sworn i followed my service manual instructions.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version