Maintenance & Technical > KX500 Original
new kx500 V-force
BigGreenMachine:
I have that cage in my 88 500. It came from an 85 Kawasaki KXT Tecate 250.
doordie:
--- Quote from: BDI on September 09, 2007, 08:05:34 AM ---
--- Quote from: kaw rider on September 08, 2007, 03:29:36 PM --- I have the v-force 3 in my motor now. more volicity then the 2's.
--- End quote ---
what v-force 3 valve are you using do you have the part number or bike that It normaly goes In.
--- End quote ---
I got Vf3 from KX250 before-05 and you have seen my K5 at youtube and it`s rips too. :wink:
Bigger isn?t always better,you guys have heard it before,yeah? :lol:
I will stuff the space around my Vf3 valve and get less crankcase volume and see what`s happen. :|
kaw rider:
this is the set up that i have been running for sometime now. I have another set up that i will run next month. it better then this set up.
BDI:
my carb Is 42mm my custom made intake Is 42mm My intake Is the same size 42mm exactly all the way to the reed block the hole leading into the read block is perfectly matched at no time does my intake get any larger or smaller than the carb untill the air and fuel enter the reed cage. I did this on purpose to keep the intake at maximam velocity until It got Inside the motor with no excuse to slow down before hand. My carb is half inch shorter than stock kx500 and my intake is half inch shorter than stock kx500 intake. My venturi Is a full inch closer to the engine than normal. I do not know if this rendered me any more horse power but the bike is very responsive with this design and never seems to run out of rpm on flat ground.the reed I have Is barely smaller it has eight large petals instead of twelve smaller ones my reed is only a couple of milleters narrower than the 500 reed.,
kaw rider:
i would like to know how you machined out the Pwm to a 42mm. you are a first at that. common is 40.5-41mm. there another way you can get your carb closer by another 1/2-3/4". you are right the pwm is closer then the pwk.
and if you upgrade to the v-force 3 you can stuff the intake more. it's alot more narrower.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version