Maintenance & Technical > KX500 Original

KX 500 Lighting Coil

(1/3) > >>

OrangeDawg:
Anybody had the electrix 210 watt lighting coil go bad on them? I have one and it worked for about 30 minutes, then the flywheel cut through two of the three wires and the lights went out. Super bright 100 watt halogen when it worked...Anybody got a fix...? I installed per the instructiions. Came with nice billet coil side engine cover.

demographic:

--- Quote from: OrangeDawg on May 25, 2007, 08:05:06 AM ---Anybody had the electrix 210 watt lighting coil go bad on them? I have one and it worked for about 30 minutes, then the flywheel cut through two of the three wires and the lights went out. Super bright 100 watt halogen when it worked...Anybody got a fix...? I installed per the instructiions. Came with nice billet coil side engine cover.

--- End quote ---
Do you mean the Eline one?
Not had one but I was asking about them a while ago and one of our members mentioned something about needing to shim it out to stop the flywheel damaging the wires.

I was asking about the Eline kit on THIS THREAD

gil2264:
I have the Eloctrosport ESL220 Coil.  I had to have the Stator Plate bosses machined down about 3mm. to gain clearance from the fly wheel.  I routed the primary wires behind the stator plate to keep them out of harms way. 

OrangeDawg:
Yep, it's the Eline. I'll post some pix. Sounds like I'm not the only one who had some fit problems.
 :?

martinfan30:
Where is the best place to find these? I want to plate the KX5 in my near future.

Is this one the only choice? Has there been an update to fix the fitment issues? Also, what choices are there for head light assemblies?

Thanks again,

Rich.

Navigation

[0] Message Index

[#] Next page