Maintenance & Technical > KX500 Original

BRP billet exhaust mount

(1/1)

medicman:
Have any of you guys used the brp billet exhaust monut?  is this for the top mount that always breaks? also is it bolt on? or weld on?
the part is here, www.brpit.com( the part is listed under the close out section, at the very bottom)

FuriouSly:
That looks like the rear muffler mount hanger.  Definately trick looking,  but the stock aluminum one is good enough for me and I have not broke it yet.

Sly

awak100:
I'm making exhaust mounts/dampner for kx's 500 if interested, Ive been useing them for years. There tough

Polar-Bus:

--- Quote from: awak100 on June 07, 2012, 03:24:31 PM ---I'm making exhaust mounts/dampner for kx's 500 if interested, Ive been useing them for years. There tough

--- End quote ---

Dude, how many effin' times are you going to post that you are making an exhaust bracket ?  :?  I think we all get your message with the OTHER 6 posts you make the same statement.... stop archiving and spamming up multiple dead posts from like 6 years ago... thank you.

Navigation

[0] Message Index