Maintenance & Technical > KX500 Original

KX500AF coupla' shots from this morning

<< < (2/4) > >>

gowen:
I'm VERY curious about the power output with the pipe.. But, that is awesome! very clean.

AJ:
gowen,

i hava a couple of KX500AFs built now,
and i also have pipes/silencers made by FMF specificallly for the bike.

hillclimber147:

--- Quote from: AJ on April 09, 2007, 11:50:43 AM ---gowen,

i hava a couple of KX500AFs built now,
and i also have pipes/silencers made by FMF specificallly for the bike.


--- End quote ---

Any noticeable differences between a CR500 pipe and one of your new FMF pipes? Or possibly any dyno runs done for each pipe?

AJ:
the pipe i made was a one off, and just intended to get the project
 rolling.
i never planned to make biukes production with it and always intyended to have PC and FMF make a specific pipe.


as far as comparison ..
very little difference,
perhaps there was a very slight loss of bottom end on my hand made pipe..

but!!!!!!!

 i did do a bit of research with both PC and FMF before making it!!
 to match things as closely as i could to the KX500 pipe shapes and
lenghts.
That pipe took my far longer to make, than the bike itself..

but either way now that i have production pipes that hand built one is tossed at this point, having served its purpose =)

gwcrim:
Wanna toss it my way AJ?   :-D

Navigation

[0] Message Index

[#] Next page

[*] Previous page