Maintenance & Technical > KX500 Original

clutch arm

<< < (2/2)

MadKaw:
so grease the bearings down in the hole? and I didn't have to force it down, itwent down easy once I found the groove. is there anything that holds it in there, or does the cable hold it in? and yeah, it was facing rear when it went in and rotates toward the cylinder. its a 93

hughes:

--- Quote from: MadKaw on March 01, 2007, 03:27:36 AM ---so grease the bearings down in the hole? and I didn't have to force it down, itwent down easy once I found the groove. is there anything that holds it in there, or does the cable hold it in? and yeah, it was facing rear when it went in and rotates toward the cylinder. its a 93

--- End quote ---

Once you rotate if forward the push rod will hold it in place or keep it from coming up plus the cable holds it in against the push rod and keeps the arm rotated forward.

MadKaw:
thanx...should I just grease that rod real good and slide it back in then?

hughes:
I Don't. I started another post about that issue but no respones at this time.

MadKaw:
cool, thanx for the input :wink:

Navigation

[0] Message Index

[*] Previous page