Maintenance & Technical > KX500 Original
86 Rear brake help...
hughes:
See the area I marked? That's were the spacer goes.
SupermotoFan:
First off, you guys rock! I'm so happy that I've found such a good bunch of people / enthusiasts!
Hughes, you were really close--actually the spacer is there, right where it should be / where you marked in red.
I haven't pulled it apart again to inspect the bearing / inner hub spacer area yet, but when I do, I'll post my results / photos.
Thanks again to all!
hughes:
If that spacer is there then I would agree with gowen about a rear wheel bearing failure. How does the wheel feel when you spin it?? My 87 rear hub had a shoulder for the bearing to rest against once you drive it so it can't go to far into the hub. let us know.
Danger4u2:
I think there should be a pipe like spacer between the bearings inside the hub. I'm at work, I'll see if I can find an exploded view tonight after work.
hughes:
You are right there is a pipe like spacer between the two bearings. Need to check for it, the right side bearing could be press to far into the rear hub if that spacer is missing.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version