Maintenance & Technical > KX500 Original
Your thoughts on flywheel weights?
Arigato:
--- Quote from: FuriouSly on June 01, 2006, 04:50:56 AM --- Definately, the sand steals alot of snap from motors. I second the notion of machining some weight off of the stock flywheel, I need more HP out of the hole and up to 1/4 throttle.
--- End quote ---
Milling the head would help your application a lot. Wait 'till you ride mine this weekend.
gowen:
PVL is the best way to go, it is about 1/8th the weight of the stock flywheel. You want to talk about SNAP!
KXcam22:
Arigato,
When you milled your head did you reshape the chamber or just bring it down to minimum squuish? :-) Cam.
Arigato:
Just took some squish out along with a cometic high performance gasket kit. The cylinder was ported and the carb bored too. However, I've seen relatively stock motors run very well with a little head shavin'. :mrgreen:
5dracing:
I have the 11oz. on my bike, it helped with traction in the PA dirt.
Navigation
[0] Message Index
[*] Previous page
Go to full version