Maintenance & Technical > KX500 Original

'86/ '87 manual

<< < (2/2)

hughes:
Good job.  :-o

rotarymonster:
thanks again guys. i didn't expect to get this much help. Danger- this is great, although it does not show the actual bore diameter, no need to scan the previous page, but i would appriciate it if you could just post the service limit for the cylinder bore dimension please?

Danger4u2:
You were right, what you needed is on the previous page. For some reason Friday I could not log on to the net. Then weekend family stuff came into play. Had to come home to tend to the dog. I snuck down to the office to post what you need. here goes...


                    Engine Service Specifications (KX500)


                              New                              Service limit
                             mm  (in.)                        mm   (in.)

Cylinder head warp limit                                   0.03
                                                                  (0.001)

Cylinder diameter
  1983                      86.000-86.015                 86.10
                              (3.3858-3.3864)               (3.390)

   1984                     86.010-86.025                 86.10
                              (3.3862-3.3868)               (3.390)

1985-on                    86.020-86.035                 86.10
                               (3.3866-3.3872)              (3.390)

I double checked the numbers that I typed, be confident they are correct.
Danger



                     

rotarymonster:
thats brilliant, thanks a lot.

Navigation

[0] Message Index

[*] Previous page