Maintenance & Technical > KX500 Original

Learn From My Mistake!!

<< < (2/2)

hughes:
That's a good idea. The outside dia. of the seal is metal and is lightly pressed in so it shouldn't move. You could replace the crank seal without sliping the cases if both of those lips are gone.

Polar-Bus:

--- Quote from: hughes on January 13, 2006, 11:38:55 AM ---Guy's I spent the week pressing out the bearings in the engine cases. I was using a hydraulic press to remove and install the bearings. Got all the bearings installed accept the crank bearings and seals. Saved those for last. Went to installed the first crank seal using the hydro press and used just alittle to much pressure an pushed the seal through the other side. Busted the lip off thats hold the seal from popping out in the clutch area. Bone Head Mistake. The other seal went in easy using the large socket and tapping it in with the hammer. I think I can fix it with JB Weld. it's a no stress or load area it just keeps the seal in place. Wish me luck.

--- End quote ---

If any of you guys would like a "press-less" method for removing (or installing) any crankcase bearings, heres the magic trick: Place the crankcase half in the freezer over night, now QUICKLY put propane heat around the circumference of case, outside the bearing. Now quickly slam the crankcase half off a wooden workbench. If done correctly the bearings will fall right out of the bores. You can do exactly the same method to install new bearings. Place the bearings in the freezer, heat up the bores, and the bearings will slip right in. (Sorry if this is a repost of someone elses tip). Some techs will place the crankcases in an oven @300F for about an hour, as opposed to heating up each bearing bore
               Rich

Navigation

[0] Message Index

[*] Previous page