Maintenance & Technical > KX500 Original

Kx500 snowbike light

<< < (2/3) > >>

1901306708:
it ties right in ey?

you're gonna need the ricky stator gizmo, or whatever they are calling the penton/pvl ignition system these days.

motorman455:
No need for pvl depending on the wattage requirements of your light. The ricky stator is 50w and has 2 wires of ac current to directly go to a light. I have mine powering a baja designs 25w led perfectly fine.

Wilde1yamaha:
This light uses either one or two watts, I just touched the positive wire to one of the stator wired until it turned on! It works on the stock stator

motorman455:
If it is really only 1 -2 watts that shouldnt be an issue for the stock stator but are you sure about that wattage? That is very low even for an led. Maybe its 1 or 2 amps which would be 12 to 24 watts? That will compromise your spark power if its that high.

Wilde1yamaha:
Ok guys doing some more research the light draws 1 amp

Navigation

[0] Message Index

[#] Next page

[*] Previous page