Maintenance & Technical > KX500 Original
Flywheel clearance question
Bcsnowbiker:
Does the flywheel have enough clearance to run hex head bolts like in the bottom left corner or do I need to run the OEM Phillips like the top right bolt and deal with this on dissasemby?
It wasn't the worst easy out I've delt with but the Phillips was already stripped by previous owner.
Bcsnowbiker:
Wrong picture
1901306708:
I use an 8mm hex on mine and nothing rubs. I have a pvl ignition though
Bcsnowbiker:
Thanks
I will have to look more into the pvl ignition....
1901306708:
its ok. nothing to get too excited about. don't get it wet, which is hard to do on a snowbike.
Navigation
[0] Message Index
[#] Next page
Go to full version