Maintenance & Technical > KX500 Original

Is this normal?

(1/2) > >>

Bcsnowbiker:
Never seen a clutch were the plate tabs have 10mm + of clearance from the basket fingers.

Bcsnowbiker:
I know this isn't normal :cry:

Bcsnowbiker:
I have seen worse baskets but I have never seen an inner hub this notched.
In my eyes it is from the excessive tab clearance on the basket.

sandblaster:
Lol... No, it's not normal.... Someone has machined the basket a lot...
If you use it you will breaking a ton of plates...
You need to replace that basket and hub.

Bcsnowbiker:
Makes sense but never thought someone would go beyond simple filing.
I already ordered a prox basket and inner hub last night.
Recommendations on plates and springs?
When I did up my rm250 motor I had issues finding plates/springs that didn't slip.
In the end wiseco were the best with Barnett springs but they are not available for the kx.
I was thinking of going with the Barnett Kevlar plates.

Navigation

[0] Message Index

[#] Next page