« previous next »
Pages: [1]   Go Down

Author Topic: 1998 kx250 output shaft  (Read 2023 times)

0 Members and 1 Guest are viewing this topic.

Offline Troy5157

  • Newbie
  • *
  • Posts: 4
1998 kx250 output shaft
« on: April 04, 2019, 06:51:12 AM »
Recently broke a tooth off my output shaft after sprocket broke.  Cant find a decent shape output shaft off a 98 or 97 to replace with. Found a 99 but the part number is different. Only difference I can see is the number of teeth at the end of the shaft for the sprocket. Anyone else know if it will still work in a 98? Thanks
Logged

Offline KXDINO

  • Hero Member
  • *****
  • Posts: 630
Re: 1998 kx250 output shaft
« Reply #1 on: April 04, 2019, 07:23:59 PM »
if you can compare them side by side and the only difference is spline count , it will work, buy the shaft and let us all know if it doesn't resell it. the coarse splines were out , I just fitted one of mine k5 with a brand new shaft as it had a lot of sprocket movement and couldn't bare it any longer.
Logged

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,272
    • OEM-CYCLE QUALITY USED PARTS
Re: 1998 kx250 output shaft
« Reply #2 on: April 05, 2019, 01:57:16 PM »
I swapped a 99 trans into some 98 cases.
Everything swapped over with no issues but I did swap the entire trans.
Logged
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline Troy5157

  • Newbie
  • *
  • Posts: 4
Re: 1998 kx250 output shaft
« Reply #3 on: April 06, 2019, 10:18:10 AM »
Ok awesome. I'll prolly buy the 99 shaft and see if it fits. If not just sell it and keep looking. Really wanna avoid welding the sprocket to the old shaft.
Logged
Pages: [1]   Go Up
« previous next »