Maintenance & Technical > KX500 Original

wossner piston rings

(1/2) > >>

Abbott:
Hey guys. wanted to replace my piston rings before the new season. Bike has a wossner piston in there now. Where do you guys recommend getting new rings from?

Foxx4Beaver:
I've always gone straight to the source  https://wossnerpistons.com/ 
...but I think Sandblaster and Alward25 used to sell Wossner products too...you can try givin them a PM.

Abbott:
I did send wossner an email this morning. See what they say. Ill hit up sandblaster also

Abbott:
Yeah sure enough my end gap is ~.022-.023". Definitely need rings. I dont have a lot of hours on this top end and i noticed some very small pit marks on the cylinder wall. Not too happy about that. Also see the crank is covered in oil. Need to see if thats transmission oil or if the petcock didnt seal right and its 2 stroke oil left over after the gas dissolved? Everything always turns into a bigger job hahah

Abbott:
Pits

Navigation

[0] Message Index

[#] Next page