Maintenance & Technical > KX500 Original

How do you clean your pipe?

(1/3) > >>

sandblaster:
How do you clean your pipe?

http://www.oem-cycle.com/forum/viewtopic.php?f=119&t=1399

Heniz:
Awesome I will keep an eye out for these!!!

I normally sandblast it torch the welds and coat it in high temp clear  :x

DEP factory pipe

motopunk:
steelwire wheel , 3m scotchbrite pad and wd40 ...   but there is a good way to prevent this bad rusty conditions..   spray it with wd40 or better put weapon-oil on it with a towel after every ride and clean ...my dep-works-pipe had a interesting llightbrown patina by the time   :wink:

sandblaster:
Nice guys!  8-)

Ims Roll:
Steel with rust from the inside out if you clear coat it... Not a super good idea. But nothing beats elbow grease and hardwork with some scotch bright to make a pipe shine.

Navigation

[0] Message Index

[#] Next page