Maintenance & Technical > KX500 Original
K5 vibrates real bad.
dirkster:
got the jetting close with the 55 and 168 needle on second from bottom clip.
Foxx4Beaver:
how's it seem to be running now?...any improvement?
Foxx4Beaver:
that plug looks a touch lean...is that after a WOT chop with your new settings?
dirkster:
--- Quote from: Foxx4Beaver on November 10, 2016, 11:10:34 AM ---how's it seem to be running now?...any improvement?
--- End quote ---
it does run better. but found another problem, about a 4" long crack in the expansion chamber just behind the main mount and a crack near the spring hook. think that could cause some running issues?... i can get the pipe brazed, or i can put jb weld over it since it a bit large and order a new pipe tonight.
--- Quote from: Foxx4Beaver on November 10, 2016, 11:19:42 AM ---that plug looks a touch lean...is that after a WOT chop with your new settings?
--- End quote ---
that was with the new setting a few wot 1-5 runs think i might do the 170 and set the needle on the 4th notch
Foxx4Beaver:
you could weld the pipe, no problem...I myself, would just take the plunge and buy a new FMF Desert, or PC2 Platinum.
Yeah, I would go with the 170, like I originally mentioned, and try a few more runs.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version