Maintenance & Technical > KX500 Original
1985 KX500 questions
Abbott:
On the mill this afternoon. Forgot to take an after picture. Will get one tomorrow
Center piece was broken. Couple tacks back on it. Polished the pipe up while I was at it.
Abbott:
Another shot of the polished "DG" pipe.
Finished maching. That little cavity will also be filled in.
New beefed up billet T6061 aluminum sleeve that has been TIG welded. This one shouldn't snap!
Abbott:
I need to send the cylinder out for a strip and re-plate...who do you guys recommend?
Foxx4Beaver:
--- Quote from: Abbott on March 20, 2016, 11:25:13 PM ---I need to send the cylinder out for a strip and re-plate...who do you guys recommend?
--- End quote ---
PowerSeal or Millennium....
http://www.powersealusa.com/
http://mt-llc.com/
PowerSeal's in Pennsylvania, and Millennium's in Wisconsin...which ever you're closer to would be the one you want...they're both good.
sandblaster:
Nice job on the repair...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version