Maintenance & Technical > KX500 Original
boot to reed cage gasket
Foxx4Beaver:
absolutely....whomever you send the cylinder off to, make sure you let them know it's cracked...take a black Sharpie and mark where it is. Most places are pretty good at looking for, and finding cracks on their own...but you'll be better off pointing it out. Check it really good for others too, around the intake bridges and exhaust.
1FAST450R:
probably a good thing I looked at it.lol I already spoke with millennium technologies and plan on sending it to them. I guess a $450+ top end job is cheaper than a total rebuild. :-(
1FAST450R:
Is millennium technologies the best place to go? I want to get done correctly so i'm not rebuilding again too soon.
Foxx4Beaver:
if you're closer to the west coast, then I'd go with Millenium....if you're closer to the east coast, then I'd go with Power Seal.
Either place is good....it just comes down to "turn-around" time...choosing the one that's closer to you.
1FAST450R:
im in Maryland. I will look into Power Seal.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version