Maintenance & Technical > KX500 Original

head gasket problem, advise needed

(1/1)

trgracing:
hi,

ive read it somewhere on here some where, but cannot find it,

i purchased a couple of kx 500,s  3 or 4 years ago,   years 2001,  recently i thought i would use it,  so after a check over, i found it had nipped up- siezed on the top end,
so after a strip down of the top end, i found the cylinder above the piston, had very light marks ( rust ) i think from a leaking head gasket.......so i sent it for a cylinder re plate, and a fresh top end.

my question is,  ive read you guys lap the cylinder/head ?  can i check for any warp on the head ?   any advise is welcome

 

Foxx4Beaver:
read through this...good stuff, should answer your questions...

http://www.oem-cycle.com/forum/viewtopic.php?f=39&t=421
http://www.kxriders.com/forums/index.php/topic,11552.0.html

Navigation

[0] Message Index